How to Prevent Fire Caused by Home Decoration Wire and Cable Load

Home improvement wire and cable in operation, along with the continuous hot resistor, prone to line overload, resulting in temperature rise, will cause fire accidents, so how to prevent home improvement wire and cable load caused by fire?

1. In the route design link, the volume of the site should be accurately checked, and the probability of increasing the new capacity in the future should be comprehensively considered, and the suitable wire type should be selected. If the volume is relatively large, you should choose a thicker wire. Circuit principle and scientific and reasonable selection are the key factors to avoid overload. If the design selection is unreasonable, there will be a congenital security risk that can not be corrected. Some small programs and places are not carefully planned and judged, and they are extremely dangerous to choose and pave routes casually. A new household appliances, electrical equipment should comprehensively consider the bearing capacity of the original line, the original route does not meet the conditions, should be repositioned and updated.

2. Home improvement wire and cable shall be constructed and laid by qualified staff according to relevant standards. The laying standard of the line is directly related to the heat removal of the transmission line. Generally speaking, the line laying is not suitable for crossing flammable articles and accumulation, which will also lead to poor heat removal and heat accumulation of home decoration wires, which is likely to ignite flammable materials around, thus enhancing fire safety hazards and overweight. The upper limit route of public leisure and entertainment clubs shall be maintained with seamless steel pipes to separate the decorated ceiling from the route. Even if there are overweight, short circuit faults and other molten beads, they will not burst out to prevent fire accidents.

3. Improve power management, prevent disorderly line, careful use of mobile sockets. The use of mobile sockets, in fact, is in a certain part of the line to enhance electrical equipment, enhance the current flow, which may cause the load. The mobile socket significantly exceeds the mobile power socket on the wall. If too many household appliances are used on the power socket of the mobile phone, the original power circuit will be unbearable. For high-power equipment and household appliances, independent routes should be set up, and mobile sockets should not be used as wiring sources.

4. Accelerate the transformation of old lines and eliminate fire hazards. Relevant units such as old communities and old communities have been used for a long time. Several circuits are aging and exceed their service life. Even if the current-carrying level of some lines is not large, the aging lines are also difficult to tolerate. Such current-carrying levels are also at risk of load. Especially in the old community, the route has long been aging, but with the improvement of people's living standards and the improvement of electrical products, the power consumption is still increasing year by year, which really adds fuel to the fire.

home decoration must use flame retardant wire?

Many users in the home decoration some confusion, should not use flame retardant wire? Flame retardant wire refers to the function of flame retardant wire, because it has the function of obstruction, delay flame combustion is widely used, mainly used to do engineering building decoration lighting transmission and transformation, its performance parameters and general wire is similar, relative general wire, flame retardant wire practical value is higher. Because modern home decoration has improved a lot of high-power electrical appliances, it is easy to have electrical safety problems. Flame retardant wires are not only better in quality than ordinary wires, but also have relevant flame retardant tests and verifications in life. In case of fire and other emergencies, flame retardant wires can control the combustion within a range to prevent the fire from spreading and damaging another one.