Power cable crimping process - crimping
1) The selection of the position of each indentation should be carried out according to the marked position and regulations on the connecting pipe or terminal cylinder. The axial centerline of the partial crimping pit or the center of the opposite side of the inscribed circle in the hexagonal overall crimping. The lines should all be on the same straight line. The crimping degree shall be subject to the contact between the lower die and the lower die or the effective stroke specified by the crimping pliers. After pressing an indentation, it should stay for 10~15S. Then remove the pressure. The operation method of the press clamp should be carried out according to the procedures specified in the press clamp manual of the press clamp manufacturer.
2) After pressing, use a fine-tooth file to remove the water chestnut edge of the pressure pit and the end of the connecting pipe due to pressure, polish it with sandpaper, and then wipe it with a cotton cloth dipped in gasoline. Rinse the conductor connection joints of oil-impregnated paper insulated cables with cable oil heated to 120~130℃. To remove moisture and contamination, and then wrap the insulation at the joint.
3) For cables of 6kV and above, if local crimping is used, the surface of the connecting pipe should be covered with a layer of metallized paper or two layers of aluminum foil after crimping to eliminate the effect of power plant distortion caused by the pressure pit. The pit should be filled with bitumen insulating glue (or epoxy resin) first, and then the metal shielding should be wrapped. Terminals can be based on requirements, do not necessarily need to fill the pressure pits and wrap aluminum foil and so on.
Previous page:
Next page:
Kunming Kunbao Wire and Cable Manufacturing Co., Ltd.
The company mainly produces bare wires, wires and cables for electrical equipment, power cables, data signal cables and special cables, with more than 1,800 varieties and specifications.
contact us
Marketing Tel: 0871-67388840 67388841
Contact: Ms. Liu 18213841134 Mr. Yang 18468235195
Marketing Headquarters: 11th Floor, Building 1, Dongju Jiaxin Business Center, Guandu District, Kunming City, Yunnan Province
Production Base: No. 15 Shaoyun South Road, Qidian Industrial Park, Chenggong District, Kunming City, Yunnan Province
Tel: 0871-67333199 Fax: 0871-67334199
the public
© COPYRIGHT 2022 Kunming Kunbao Wire and Cable Manufacturing Co., Ltd. ALL RIGHTS RESERVED | SEO
Technical support: www.300.cn Kunming